At their heart, a rigging screw is a device designed to modify tension in a cable or wire rope system. Turning the body causes two ends to move towards each other, bringing two end fittings closer together or farther apart, thus tightening or loosening what these two ends are attached to. Of course, this is what rigging screws are designed to do: make it possible to adjust tension once a system is in place, and make it possible to adjust tension periodically as cables stretch over time.

It is a simple yet clever design. There is a body in the middle with left-hand and right-hand threading on either side of it. Turning the body causes both ends to move towards each other at twice the rate they would have moved had there been a single thread system in place. Most rigging screws have a window on the body of the device so you can check that both threaded studs are securely attached without having to remove either one.

The types of end fittings will vary based on what you are attaching things to. Eye and eye types work well for cable loops and shackles. Jaw and jaw types work well for clevis pins. Hook and eye types work well for quick attach situations, but should not be used in situations requiring high stress usage. Fork and eye types work well when some form of rotating motion is required.

Load Ratings That Matter

The rigging screw has a Working Load Limit, not breaking strength. Now, this is a very significant difference. The Working Load Limit is a measure of the maximum loads that a piece of equipment will ever see, with a 4:1 or 5:1 safety factor built in. So, a rigging screw has a WLL of 500kg. It does not mean that it will break until you get up to 2,000-2,500kg. However, you should not get anywhere near these limits. The weak points are in the threaded connections, not in the rigging screw. Threads concentrate forces in small areas, particularly in the first few threads.

This is why thread engagement is so vital, particularly in most specifications, where there should be a minimum of 75% of the length of the threads engaged. The size of the rigging screw has a very significant impact on the rigging screw. However, it does not have a straightforward impact. If you go from a 10mm diameter rigging screw to a 12mm diameter rigging screw, it does not mean that the new screw will have a 20% increase in load rating. It will actually have a 45% increase in load rating due to the increase in area.

Installation Details That Get Overlooked

Lubrication of the threads is not often considered a significant factor in the installation of rigging screws. However, it has a significant impact on the usability of the screw in the future. Dry threads can cause problems in the future should it ever need to be adjusted. A light coating of grease or anti-seize can work wonders in the future. Marine environments have specific lubricants.

These mechanisms will differ in design, with some using jam nuts, which tighten on the body after the desired tension is achieved. Others will use lock wire, which is threaded through holes in the body and the end fittings. Split pins will be used when there is the possibility of vibration, which would cause the parts to rotate.

Leave a Response